Sliding Snell Knot: How to Tie a Sliding Snell Knot Video

Pass the loop through the hole in the overhand knot one more time. Different situations call for different knots. The knots needed for tying fishing line to a hook are different from the knots needed to join two sections of line together. Tighten knot with a steady, even motion without hesitation. Trim double loop and end of braided line leaving about 1/4 inch. Run end of line through eye of hook or lure and double back through the eye a second time.

If you follow the directions in the video above, you’ll be able to the tie the non-slip loop knot like a pro. The ends of most fishing knots can, and should, be trimmed closely against the knot. The best tool for the purpose is a nail clipper. This image shows one typical system for fly fishing. It shows examples of knots that can be used at each junction. The purpose of the tippet is to prolong the life of the leader by replacing it when enough has been lost through breakage, re-tying flies, or damage on snags.

WHAT BAIT TO USE WITH DIFFERENT KIND OF KNOTS

There’s a good argument that the uni knot is marginally superior to the blood knot, but both work well when tied correctly. Loop knots are preferred when attaching lures and flies to heavier lines or leaders, as they enhance the action of these artificial baits. The uni knot is one of the oldest and most reliable fishing knots, saltwater and freshwater alike.

Now that the end has been passed twice through the eye. Try to get a good grip over the hook eye and both parts of the line. Wrap the loop around the shank of the hook at least 7 or 8 times. Shrink the loop by pulling on the standing end. Now you need to moisten and pull both ends so that the knot is well-tightened. While tying an improved clinch knot, you must be careful about pulling the knot.

Step 6

The only well-documented method of tying knots in monofilament and maintaining its strength involves threading the monofilament inside a dacron braid. The report claims that with this technique breaking strains of 90% of the ideal were achieved. Ideal breaking strength is tested by winding each end around very large diameter drums.

The second, equally insidious, form of slip failure occurs when one or more turns of a knot slip just enough under load to momentarily create an intense friction point. During an intensive fishing session, an angler might tie a dozen or more knots in just a few hours. A snug knot is more likely to hold than a loose one.